Amana Dryer Brackets and Flanges

Your Price

$62.65

Amana Dryer STACK KIT FOR LONG VENT DRYER

★★★★★

1 Review

PartSelect Number PS12069913

Manufacturer Part Number W10869845

Installation Instructions

Nelson from Middletown, NY

Washer Would Drain But Not Spin

Removed rear cover (6 screws) unpluged harness from motor control and removed same. Replaced motor control reinstalled harness. Replaced rear cover. Parts used motor control board. Read more...

Your Price

$51.94

Amana Dryer Stacking Kit

★★★★★

6 Reviews

PartSelect Number PS888067

Manufacturer Part Number 8541503

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

Installation Instructions

Randy from Brentwood, CA

Placing Dryer on Top of Washing Machine with Stack Kit

I purchased a stack kit from "Part select.com". The item was just what I needed to do the job. The delivery of the part was made the next morning. WOW! Excellent service! The process was completed in less than 24 hours, start to finish. Very impressed! Read more...

Your Price

$48.27

Amana Dryer Stacking Kit

★★★★★

2 Reviews

PartSelect Number PS990537

Manufacturer Part Number 8572546

This kit allows you to stack your washer and dryer to maximize your laundry space.

Your Price

$60.48

Amana Dryer Plate

PartSelect Number PS11750411

Manufacturer Part Number WPW10208419

Your Price

$14.56

Amana Dryer Bracket, Ignitor

PartSelect Number PS11743787

Manufacturer Part Number WP694298

Your Price

$74.78

Amana Dryer Glide Bracket Kit

PartSelect Number PS2003560

Manufacturer Part Number 12002090

This kit contains two glide brackets and four screws.

Fixes these symptoms

Noisy
See more...

Installation Instructions

David from Underwood, IA

Loud banging sound. Worn out roller.

Pulled off the lower panel with 5/16 socket.Pulled off the door assembly by removing the two screws at the bottom of the door assembly. I pulled down a little and then out. be carefull of the wires. Other posts said to remove. The wires were long enough I did not have to remove them. I just leaned it against the wall. I then removed the 4 screws that hold the front piece in.pulled it off replaced brackets , installed self adhesive felt(stuck good) and then glides. Mine were thin but not the problem. I then reached under the drum and released the belt from the tensioner. I then pulled the whole drum out.This is the time to vacum out good. I could get to the rear rollers very easy. The left roller was shot and the shaft half wore into(the problem). I pulled off the two screws holding the roller support. Normally You have to remove the wheel with snap ring pliers first to remove the support. In this case snap ring long gone. Replaced support shaft, installed thrust washers and roller with grease for both sides. The right support shaft was still good. Removed tensioner pulley and inspected. It was just as good as the new one. Cleaned and greased and reinstalled. Put new belt on the tub and slid it back in. Be carefull to get the belt on the proper side of the tensioner. I then installed the front supprt in place to support the tub with the 4 screws. Spun the tub(felt good) then reached under and reinstalled belt to motor and tensioner. Spun again to check for belt alignment. (Check) Reinstalled door an lower panel. Test Quiet Sounds like new. Very easy! I hope this helps someone just as the other post has helped me. Blessings to all. Read more...