The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the door latch is open or c...
$45.13
In Stock
Order within the next 10 hrs and your part ships today!
Order within the next 10 hrs and your part ships today!
Questions And Answers for EW30SO60QSA
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Michael
February 25, 2020
Drop down door handle has become very loose. Screws or bolts that hold handle
To door are not accessible because inside panel of door is attached to door by
Some sort of adhesive.
For model number EW30SO60QSA
Hello Michael,
Thank you for your question. Remove the door from the oven, most doors you just open to the first stop point and lift up on the door. Then, most doors have screws on the top and bottom, some also have them on the side, remove those screws and the front and back of the door will separate, the screws that hold the handle are in there, and you should be able to tighten them to fix the loose handle. Remember to use caution with the glass when separating the door panels. We hope this helps.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Alexander
June 21, 2023
Loose door.
How to remove door for examination.
For model number EW30SO60QSA
Hello Alexander, thank you for your inquiry. We have found some relevant instructions for you to remove the door. They may not be of the exact same model, but they will help you with the process. You may follow the following steps: open the door completely that is until it is parallel to the floor. At the bottom of the door where it connects to the bottom of the microwave, there is a small lever on either side located at the hinges. Lift them both up. Completely shut the door, slowly past where the door rests. Open it up to the point where you can not close it anymore. Do not try and force it past this point. Grip the door tightly on either side before lifting slightly up and then downwards and away from the microwave. We hope this information is useful!
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up.
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a
... Read more 12 volt battery and it was bad. Ordered a new one from Part select and got it fast . Works great .
After unplugging the unit remove the control face buy removing the screws. All three door switchs are on a bracket on the left. Remove the two screws holding the bracket in place and pull out. Disconnect the wires from the three switches and test each switch indivually to determine the bad one. I used a multimeter set on ohms.Replace the
... Read morebad switch with the new one and replace all the wires. Reassemble the unit and you are good to go.