Using trash compactor bags is a practical way to remove your waste. Because compactors use such high pressure to compress the waste, using compactor bags designed to handle the force are a necessity. ...
$90.12
In Stock
Order within the next 8 hrs and your part ships today!
This is a top limit directional switch for a trash compactor. The directional switch reverses the motor direction when the trash compactor has reached the top of the drawer. If your trash compactor is...
$10.77
In Stock
Order within the next 8 hrs and your part ships today!
This power nut assembly is made to be used in conjunction with your trash compactor. It comes with five pieces that include the two mounting pins, two clips, and the new power nut. This piece is beige...
$12.66
In Stock
Order within the next 8 hrs and your part ships today!
If your trash compactor is jammed or stuck with the ram in the down position, you may have a faulty or damaged drive gear. The drive gear is located at the bottom of your compactor, and helps the driv...
First I removed the trash compactor from the cabinet and transported it to the garage to avoid scraping the kitchen floor....I then removed the the sheetmetal cover enclosing the motor by removing several sheetmetal screws. To remove the motor, I then removed the compactor drawer and tilted the compactor onto its front (the side you pul
... Read morel the drawer in and out of). This allow you to get to the bottom of the compactor. I then removed 3 sheet metal screws attaching the bottom cover of the compactor. After removing the bottom cover, I could then access the 4 mounting nuts that hold the motor in place. I disconnected the wiring harness to the motor, removed the motor and replaced it. The motor plate allows you to adjust the chain tensioning and gear lash of the drive motor. I adjusted and tightened the plate to provide close gear lash, and chain tension of about 1/2" play. Re-installed the motor cover and bottom plates, plugged the compactor into a wall socket, re-installed the compactor drawer and tested for several cycles. All is well. FYI - I do not think the motor itself was bad; however, there is a centrifugal switch built into the motor assembly...that is what I believe failed. The motor and centrifugal switch come as a one assembly.
Removed compactor from opening. Using screw driver unthreaded 4 screws from top and then removed the on/off dial. Face plate came off easy and provided access to relay switch bank. Unscrewed two screws which allowed both relay switches to be removed and replaced. Recommend replacing both relay switches. Reassembled and compactor work
... Read moreed fine. Very easy job. If your compactor is making a machine gun noise during the return cycle then this will solve your problem.
The wire harness from the part supplier was set up wrong, two of the three wires were switched and it damm near burned up the new motor. I had to correct the error by switching the wires around so that they matched the wireing from the original motor.