Weed Eater Lawn Tractor Pulleys

Your Price

$13.69

Weed Eater Lawn Tractor Ground Drive Fixed Idler Pulley

PartSelect Number PS9016377

Manufacturer Part Number 532194326

This ground drive fixed idler pulley is for lawn tractors. 910 inch offset Ground drive fixed idler pulley helps apply tension to the drive belt, allowing the belt to turn. Wear work gloves to protect your hands when installing this part.

Fixes these symptoms

Drive system does not work
See more...

Your Price

$13.69

Weed Eater Lawn Tractor Pulley Idler Flat

PartSelect Number PS9016399

Manufacturer Part Number 532194327

This flat idler pulley is a genuine OEM replacement part for use in outdoor power equipment. It is made of plastic and features a metal bore adapter, and a radial-style single row bearing. The pulley has an outside diameter of 3.5 inches and a height of approximately 1.5 inches. The pulley is responsible for maintaining tension on the drive belt, which allows power to transfer from the engine to the transmission. It also keeps the belt in position and acts as a shock absorber to minimize stress on the belt. If the idler pulley is damaged or worn down the drive system will likely not work, and the belt may slip off or tear, resulting in a loss of engine power. To access the pulley, you will first need to remove the belt. Disconnect the old pulley and place the new one in position. Once the new pulley is secure, you can rethread and tension the belt, making sure to follow your equipment specifications.

Fixes these symptoms

Drive system does not work
See more...

Your Price

$11.20

Weed Eater Lawn Tractor Pulley, Mandrel

PartSelect Number PS9014454

Manufacturer Part Number 532173436

Your Price

$26.14

Weed Eater Lawn Tractor Pulley

★★★★★

1 Review

PartSelect Number PS9286701

Manufacturer Part Number 532177968

Installation Instructions

Steven from Hickory, NC

Lound deck noise when mower put into motion

Parked mower on level concrete drive, laid on cardboard. Lowered mower deck all the way. Sparayed some WD40 on nut/bolt on top of old pulley. Since it is a carriage type bolt, placed 5/8" boxed end wrench over self locking nut on top of old pulley. Using some force from 3lb mallet to break nut free (hitting against wrench body), the nut came off easy as did broken pulley/bearing inside. Installed new pulley assembly, re-tightened nut on bolt. Checked after first mowing just to be certain pulley was in place and locking nut tight. Read more...